Installation Guide

Tools and Materials
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and web site are listed on
the back cover. Thanks again for choosing Kohler Company.
Before You Begin
Deep rough-in kit #73444 allows an additional 1/2” (1.3cm) of tile
thickness.
Please read all instructions before you begin.
Observe all local plumbing and building codes.
Before installation, unpack the new faucet and inspect it for damage.
Return the faucet to the carton until you are ready to install.
Leave the protective sleeve on the spout supply tube until the spout
is installed. The spout has an O-ring sealing surface which may be
damaged if unprotected.
Provide an access panel to the valves from under the deck.
Installer-supplied copper tubing is to be 5/8” O.D. (1/2” nominal).
Install water hammer arrestors in the supply lines near the valves.
These instructions cover two methods of installation; installation on
finished deck or rim, and installation on rough (unfinished) deck.
Follow the sections that pertain to your particular installation.
1017937-2-A 2 Kohler Co.