Installation Guide

Installation on Rough (Unfinished) Deck (cont.)
Do not solder the connections at this time.
NOTE: The valve body marked “Cold” must be on the right side
when you are facing the front of the faucet.
Insert the valve bodies through the mounting holes from the bottom
of the deck.
Place a collar with the flange side up, onto each valve body. Thread
the collar down to at least 1” (2.5cm) from the top thread on the
valve body.
Install a threaded sleeve fully onto each valve body.
Thread each collar until it contacts the sleeve.
1017937-2-A 8 Kohler Co.