Dimensions Guide

Technical Information
Required Accessories
K-304-* Rite-Temp
®
valve OR NA
K-2971-KS HiFlow Rite-Temp valve with stops NA
*For a complete listing of all the Rite-Temp valves, refer to the K-304-* Specification sheet or Roughing-In sheet.
Optional Accessories
88526 HiFlow Rite-Temp
®
thin
wall installation kit
CP Other
__
1030932 Deep roughing-in kit for
Rite-Temp
®
valve (lever
handles)
NA
Installation Notes
Install this product according to the installation guide.
Install the Rite-Temp
®
valve according to the valve installation
guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7 (178 mm) to 18
(457 mm) with single elbow between valve and wall-mount
spout.
1/2" NPT
1/2" Hot
1/2" Cold
4-7/16" (113 mm)
Ø 7" (178 mm)
5-1/2"
(140 mm)
72" (1829 mm) - 78" (1981 mm)
to Floor (Typical)
5-5/8"
(143 mm)
4" (102 mm)
to Top of Rim
10"
(254 mm)
48" (1219 mm)
to Floor
(Shower Only)
For slip-fit spout, 5/8" OD tube must
extend 1-1/2" (38 mm) min to 2-7/8"
(73 mm) max beyond the finished wall.
For 1/2" NPT spout, pipe must extend
3-3/4" (95 mm) beyond the finished wall.
2-3/4" (70 mm) Thin Wall
3-1/2" (89 mm) Thick Wall
Complete bath and shower faucet with Rite-Temp valve and
slip-fit diverter spout shown.
Product Diagram
DEVONSHIRE
®
RITE-TEMP
®
DEVONSHIRE
®
RITE-TEMP
®
PRESSURE-BALANCING BATH/SHOWER VALVE TRIM
Page2of2
1012741-4-
F