Specification

Technical Information
Required Accessories
K-304-K Rite-Temp valve without stops, NPT connections ❑ NA
K-304-KS Rite-Temp valve with stops, NPT connections ❑ NA
K-306-KS HiFlow Rite-Temp valve with stops, NPT conn. ❑ NA
K-304-KP Rite-Temp valve with PVC connections ❑ NA
Recommended Accessories
88526 HiFlow Rite-Temp
®
thin
wall installation kit
❑ CP ❑ Other
____
Optional Accessories
1030932 Deep roughing-in kit for
Rite-Temp
®
valve (lever
handles)
❑ NA
Installation Notes
WARNING: Risk of damage to the K-306-KS
valve assembly. When using the K-306-KS valve
in a fiberglass or acrylic installation, use the thin
wall installation kit (88526).
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″ (45.7
cm) with single elbow between valve and wall-mount spout.
1/2" NPT
1/2" Hot
1/2" Cold
Top of Rim
4-7/16" (11.3 cm)
7" (17.8 cm) D.
Complete Bath and Shower Faucet with Rite-Temp
Valve and Slip-Fit Diverter Spout Shown.
For Slip-Fit Spout, 5/8" OD Tubing
Must Extend 1-1/2" (3.8 cm) Min; to
2-7/8" (7.3 cm) Max Beyond the
Finished Wall.
3-1/2" (8.9 cm)
Thick Wall
2-3/4" (7 cm)
Thin Wall
5-5/8"
(14.3 cm)
5-1/2"
(14 cm)
72" (182.9 cm)-
78" (198.1 cm)
To Floor (Typical)
10"
(25.4 cm)
4"
(10.2 cm)
48" (121.9 cm)
To Floor
(Shower Only)
Product Diagram
DEVONSHIRE
®
RITE-TEMP
®
DEVONSHIRE
®
RITE-TEMP
®
PRESSURE-BALANCING BATH/SHOWER VALVE TRIM
Page2of2
1012741-4-
D