Installation & Assembly

Tools and Materials
Before You Begin
CAUTION: Risk of property damage. Select 500 lb (227 kg)
load bearing 5/16″ lag bolts with a length to clear obstacles
in the wall and 5/16″ washers. Calculate proper lag bolt
length by adding the following: 1-1/2″ (38 mm) backing
material + wallboard thickness + back rail thickness.
IMPORTANT! Risk of product damage. Do not modify the vanity.
Doing so will compromise structural stability.
NOTICE: Siliconized acrylic caulk must be used to secure a sink or
countertop to the vanity. Do not use 100% silicone sealant which
will damage the finish of the vanity.
NOTICE: Any electrical accessory components must be connected
to a circuit protected by a Ground-Fault Circuit-Interrupter (GFCI)
or Residual Current Device (RCD). Follow all local electrical codes.
Your product may appear different than the one illustrated. The
installation procedures remain the same.
Observe all local building codes.
Two people should install this product.
Secure the vanity to stud framing. When possible, provide 2x6
bracing behind the finished wall for additional support.
This vanity is designed to allow most base moldings to pass
behind the vanity.
To ease installation, remove drawers from the vanity before
beginning. Refer to the section in this guide for proper removal.
Plus:
• Wood Screws
• 2x6s, 2x4s (Optional)
• 5/16" Lag Bolts and Washers
[Min 500 lb (227 kg) Load Bearing]
• Socket Wrenches
• Side Cutters
1216526-2-F 2 Kohler Co.