Instructions / Assembly

ManualsBrandsKokols ManualsBathKalki Pedestal Combo Bathroom Sink in Frost Green

Things you might need for the installation:

vessel sink,

•

plumber's putty(home depot), liquid nails(home depot),

• Bucket

•

silicone caulk(home depot),

•

• Putty knife

• Plumber's putty

• Pipe wrench

• Channel-lock pliers

• Teflon tape

https://www.youtube.com/watch?v=_IxwNgRPsdc

video for a similar glass vanity set, it shows you the basic plumbing configuration. Your plumbing might

be a little different, so consult with your plumber.

Summary of content (14 pages)

PAGE 1
Things you might need for the installation: vessel sink, • • • plumber's putty(home depot), liquid nails(home depot), Bucket silicone caulk(home depot), • • • • • • Putty knife Plumber's putty Pipe wrench Channel-lock pliers Teflon tape https://www.youtube.com/watch?v=_IxwNgRPsdc video for a similar glass vanity set, it shows you the basic plumbing configuration. Your plumbing might be a little different, so consult with your plumber.
PAGE 2
PAGE 3
PAGE 4
k
PAGE 5
PAGE 6
PAGE 7
Step 1: Line Up the Drain Hole with the Cutout • Line up the sink’s drain hole with the cutout in the countertop. The homeowners in this project had the pros who supplied and installed the countertop handle the delicate job of cutting holes for the sink and faucet assembly Step 2: Apply Putty to the Underside • Roll out a bead of plumber's putty about 1/4" in diameter and place it around the underside of the drain.
PAGE 8
Step 3: Attach a Rubber Gasket On the underside of the counter, attach the rubber gasket, plastic washer and lock nut to the drain. Then, attach the drain stem. It is important that the hole for the drain through the top of the counter is not too large. It needs to be just big enough to allow the drain's pipe through. The thin metal ring and a retaining nut that screw onto the pipe from under the counter actually "clamp" the sink down.
PAGE 9
Slip the lower fastening ring and nut onto the threaded end of the pipe. Hand-tighten and then use the pipe wrench to firmly secure the sink in place. Step 4: Dry-Fit the Pipes and Fittings Dry-fit the PVC pipe and fittings, including the P-trap, making cuts as needed.
PAGE 10
PAGE 11
This is demo how the drain connected to your ptrap without the glass top & vessel sink. In real installation, you should put the drain the the surface of the glass top, bottom drain connecting the ptrap. Step 5: Apply Primer and Cement Apply PVC primer and PVC cement to the appropriate surfaces and assemble the drain, tying it into the roughed-in waste pipe. Make sure to hold each connection together for several moments so the chemical reaction of the primer and cement doesn't force the pieces apart.
PAGE 12
PAGE 13
PAGE 14