User's Manual

Strap

Stud

Drywall

(A) Bracket

(B) Long Screw

Step 1

Step 2

(A) Bracket

2 x Bracket

2 x Long Screw

2 x Short Screw

(D) Strap

Dresser Wall Mounting Instructions

Top

Back Panel

Step 3

A. Locate a stud in the wall behind the dresser. {The stud is the solid wood piece that supports the wall-

you must screw into a solid support, and not directly into drywall.} Position a bracket (A) on the stud

slightly below the top of the furniture. Mark and drill a hole into the center of the stud using a 3/32” drill

bit. Attach the bracket to the stud with the long screws (B).

B. Move the dresser to its final position against the wall and mark the location of the wall bracket on the

back of the furniture. Move the dresser away from the wall and place a bracket (A) on the mark. Mark

and drill holes for the screws using a 3/32” drill bit. Attach the bracket to the top of dresser using the

short screws (C).

C. Move the dresser to its final position, and align the bracket on the furniture with the bracket on the

wall. Thread the strap (D) through the bracket as shown, and tighten until snug. Do not overtighten.

Q011

PAGE 1
Dresser Wall Mounting Instructions A 2 x Bracket B 2 x Long Screw D Strap C 2 x Short Screw (C) Short Screw (A) Bracket (B) Long Screw Drywall (A) Bracket Top Stud Step 1 Back Panel Step 2 (D) Strap Step 3 A. Locate a stud in the wall behind the dresser. {The stud is the solid wood piece that supports the wallyou must screw into a solid support, and not directly into drywall.} Position a bracket (A) on the stud slightly below the top of the furniture.
PAGE 2
Instructions d'installation murale de la commode-coiffeuse A 2 supports B 2 vis longues D Attache C 2 vis courtes (C) Vis courte (A) Support (B) Vis longue Cloison sèche (A) Support Dessus Montang Étape 1 Panneau arrière Étape 2 (D) Attache Étape 3 A. Repérez un montant de mur derrière la commode-coiffeuse. (Le montant est la pièce de bois solide qui immobilisera le meuble. Vous devez utiliser cette pièce solide, et non uniquement la cloison sèche, pour y insérer les vis).
PAGE 3
Instrucciones de montaje contra la pared de la cómoda A Soportes, 2 unidades B Tornillos largos, D Correa 2 unidades C Tornillos cortos, 2 unidades (C) Tornillo corto (A) Soporte (B) Tornillo largo Pared de yeso (A) Soporte Parte superior Perno Paso 1 Panel trasero Paso 2 (D) Correa Paso 3 A. Ubique el perno en la pared que está detrás de la cómoda. {Es una pieza de madera sólida que se fija a la pared y debe atornillarse en un soporte sólido y no directamente sobre la pared de yeso.