Owner Manual

16
To Operate in Fan Only:
• Use this function only when cooling is not desired, such as for room air circulation. You
can choose any speed you prefer.
• During this function the display will show the actual room temperature as in the cooling
mode.
• In Fan Only mode, the temperature is not adjusted.
To Operate in Dry Mode:
• In this mode, the air conditioner will operate as a dehumidifier. Because the conditioned
space is closed or sealed, some degree of cooling will continue to occur.
To Use the Energy Saver Feature:
To start the Energy Saver feature, press the Energy Saver button. This feature is
available on “Cool”, “Dry”, and “Auto”. The fan continues to run for 3 minutes after the
compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the
room temperature is above the set temperature, at which point the compressor turns back on
and cooling starts.
To Use the Sleep Feature:
To initiate, press the Sleep button. In this mode the selected temperature will increase
(cooling) or decrease (heating) by 2°F (1°C) 30 minutes after the mode is selected. The
temperature will then increase (cooling) or decrease (heating) by another 2°F (1°C) after an
additional 30 minutes. This new temperature will be maintained for 6 hours before it returns to
the originally selected temperature. This ends the Sleep mode and the unit will continue to
operate as originally programmed. The Sleep Mode program can be cancelled at any time
during operation by again pressing the Sleep button.
To Use the Timer (Auto Start/Stop) Feature:
• When the unit is on or off, press the Timer button and the “Timer On” indicator light
illuminates. It indicates that the Auto Start/Stop program is initiated.
• To switch to off press the Timer button again and the “Timer Off” indicator light
illuminates. It indicates that the Auto Stop program is initiated.
• Press or hold the Up or Down button to change the Auto Time by ½ hour
increments up to 10 hours or 1 hour increments up to 24 hours. The control will count
down the time remaining until start.
• The selected time will display for five (5) seconds and then will automatically revert back to
display the previous temperature setting or room temperature when the unit is on.
(Note-when the unit is off there is no display.)
• Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel the
Auto Start/Stop program.
To Use the Check Filter Feature:
This feature is a reminder to clean the Air Filter for more efficient operation. The LED light will
illuminate after 250 hours of operation. To reset after cleaning the filter, simply press the
Check Filter button and the light will go off.