For technical support visit visti us at www.flykolibri.
For technical support visit visti us at www.flykolibri.
For technical support visit visti us at www.flykolibri.com Important Statement Thank you for buying Kolibri's product. People who under 14 years old must not use the product. Please read this brochure carefully before using the product. You are regarded as accepting all content in this user manual when using this drone. This product is not an ordinary toy but a piece of complicated equipment which is integrated with professional knowledge by mechanic, electronic, air mechanics, high-frequency emission etc.
For technical support visit visti us at www.flykolibri.com (1) Flying Area The flying field must be legally approved by your local government. Do not fly the drone near in the airport. Keep far away from the airport more than 5km when flying a RC drone. Flying field must spacious enough and we suggest at least 8M (length)*8M (width)*5M (height). (2) Use correctly For safety elements, please only use Kolibri’s spare parts to replace the damaged parts.
For technical support visit visti us at www.flykolibri.com (5) Safe operation Please operate the RC drone in accordance with your physical status and flying skill. Fatigue, listlessness and improper operation may increase the rate of accident. (6) Keep away from rotating parts Rotating parts like propellers or motors may cause serious injury and damage. Keep face and body away from rotating parts. (7) Keep away from heat The RC drone is made of metal, fiber, plastic, electronic components etc.
For technical support visit visti us at www.flykolibri.com Safe Notice for Drone Battery * Do not put the battery on high temperature place, such as fire or heating device to avoid damage or explode. * Do not use the battery to crash or hit hard surface. * Do not put the battery in water and keep it in dry place. * Do not open the battery. * Do not leave the battery without supervision when charging. * Make sure that there is no short circuit of the power wire. * Please use the recommended charger only.
For technical support visit visti us at www.flykolibri.com Phone Charger Power Bank Computer Charging Car Charger Li-Po Battery Disposal & Recycling Wasted Lithium-Polymer batteries must not be placed with household trash. Please contact local environmental or waste agency or the supplier of your model or your nearest Li-Po battery recycling center. Check List Before Flight 1. Make sure the drone battery and transmitter battery are fully charged. 2.
For technical support visit visti us at www.flykolibri.com 5. Improper operation may cause drone crash, which may arouse motor defective and noise, and then effect the flying status or even stop flying. Please go to the local distributor to buy new parts for replacement so that the drone will return to its best status.
For technical support visit visti us at www.flykolibri.com Front LED (Green) A Propeller B Propeller Drone Bottom Housing B Propeller A Propeller Rear LED (Red) Specification Drone Size Drone Weight 66x66x37mm Charging Time for Drone Battery 25~30 mins 23g Max Flying Distance/Radius 10~15 m Camera Resolution 640*480 Propeller Diameter Ø32mm Flying Time Drone Battery 5~7 mins Frequency 2.4Ghz 3.
For technical support visit visti us at www.flykolibri.com Exploded View 1 10 2 11 12 3 2 2 4 13 5 6 6 2 7 7 4 5 8 9 No. Name 1 Drone Cover Housing 2 3 No.
For technical support visit visti us at www.flykolibri.
For technical support visit visti us at www.flykolibri.com Brief Introduction for Button Functions Left Stick Move the Stick to forward / backward / left / right to fly the drone to up / down / turn left / turn right. Right Stick Move the Stick to forward / backward / left / right to fly the drone to forward / backward / left / right. Power Switch Heading Hold Mode Push up the power switch to turn on the transmitter, and pull down to turn off.
For technical support visit visti us at www.flykolibri.com Notice: 1. Make sure the electrodes are correct. 2. Do not mix new with old batteries. 3. Do not mix different kinds of batteries. 4. Do not charge the non rechargeable battery. Pre-flight Operation Instruction Frequency Pairing 1. Turn on the transmitter switch (Picture 1) and the power indicator light flashes rapidly. Push the Left Stick all the way down to the lowest position and then release.
For technical support visit visti us at www.flykolibri.com Important Notice: Please make sure the drone is placed on the horizontal position after powering on the drone, so that the drone can work well. Checklist before Flight 1. The camera is in front of the drone. Keep the drone front away from you. 2. Power on the drone and check the direction of the rotating propellers.
For technical support visit visti us at www.flykolibri.com Calibration Instruction Please follow below steps to calibrate the drone if the drone becomes imbalance after crashing during the flight, and can not be adjusted by trimmer button and cause difficult operation. 1. Power off the drone, then turn off the transmitter switch. 2. Turn on the transmitter switch, push the Left Stick all the way down to the lowest position (Picture 6) and then release.
For technical support visit visti us at www.flykolibri.com Flying Control Notice: Every time before the drone take off, move the Left Stick and Right Stick at the same time as Picture 5 shown(45 degree inward) to start the motors. Push up the Left Stick slowly to fly up the drone or press down the one button take off .
For technical support visit visti us at www.flykolibri.
For technical support visit visti us at www.flykolibri.com Forward and backward trimmer When take off, if the drone tilts forward, press down the left stick in the center, and push the right stick backwards. Otherwise push forwards. Left and right turning trimmer When take off, if the drone head rotates to left,then press down the left stick in the center and push left stick to right. Otherwise push to left.
For technical support visit visti us at www.flykolibri.com Functions Introduction Two Take Off Methods 1. Method 1 (Take off) : After frequency pairing successful, then move the Left Stick and Right Stick at the same time as Picture 5 shown(45 degree inward) to start the motors. Push up the Left Stick to fly up the drone to certain altitude and then release the stick. 2.
For technical support visit visti us at www.flykolibri.com ▲Emergency Stop: When the drone in emergency situation and going to hit the walking people or obstacle etc., press the Take Off / Landing / Emergency Stop Button immediately and hold it for more than 1s. The propellers will stop immediately. Tip: Do not use the emergency stop function unless in emergency situation. The drone will fall down suddenly after all propellers stop.
For technical support visit visti us at www.flykolibri.com High / Medium/Low Speed Mode Switch Low Speed Mode(Mode 1) 1. Low Speed Mode is suitable for beginner. Medium speed Mode(Mode 2) 2. Medium Speed Mode is suitable for skillful pilots to play in the gentle breeze. High Speed Mode(Mode 3) 3. High Speed Mode is suitable for expert to experience aerial stunt in outdoor.
For technical support visit visti us at www.flykolibri.com The default setting is NOT Heading hold Mode. You are allowed to activate the heading hold mode function before taking off or in flight. Fly under heading hold mode, you’re required to ensure the drone front direction aligned with your front direction, DO NOT change your direction of your transmitter and keep it fly in front of you all the time.
For technical support visit visti us at www.flykolibri.com Low Battery Alarm When the transmitter in low battery, the transmitter will beep Di-di-di... to remind the user to land the drone to replace the batteries as soon as possible. Or the drone may be out of control. When the drone in low battery, the transmitter will beep Di.di.di... constantly to remind the user to land the drone as soon as possible. The flip function will turn off automatically when the drone in low battery.
For technical support visit visti us at www.flykolibri.com Spare Parts Installation Instruction Propeller Installation and disassembly Diagram When disassemble, pull up the propeller in the vertical direction (Picture 11) and remove as Picture 12. Notice: Because the propeller is blowing up structure, it should keep a bit gap between the motor housing and the propeller( Picture 13). Picture 11 Picture 12 About 0.
For technical support visit visti us at www.flykolibri.com Propellers guards installation and disassembly diagram When disassemble, remove one side of the guard from the buckle, and then pull out ( Picture 14). When install, aim the groove of the motor housing buckle and then press down (Picture 15).
For technical support visit visti us at www.flykolibri.com Download and Install the our app: Fly Kolibri The APP is suitable for mobile phone with iOS and Android system, please download from the mobile phone software store: 1. For mobile phone with iOS system, please search Fly Kolibri in APP Store. 2. For mobile phone with Android system, please search Fly Kolibri in Google Play.
For technical support visit visti us at www.flykolibri.com Spare Parts For convenience, the spare parts are listed for you to choose, which can be purchased from the local seller.
For technical support visit visti us at www.flykolibri.com XK2380-10 Camera Board XK2380-11 Receiving Board XK2380-12 USB Cable XK2380-13 Transmitter Important Notice Our company's products are improving all the time, design and specifications are subject to change without notice. All the information in this manual has been carefully checked to ensure accuracy, if any printing errors, our company reserve the final interpretation right.
29 Fail to pair the drone with transmitter The drone is underpowered or can not fly. 3 The transmitter indicator light is off 1 2 Problem No. Solution 1. The same as above 1.2.3. 1. Indicator light is off. 3. Operate the drone step by step in accordance with the user manual. 1. Replace the propeller. 2. Recharge the drone battery. 3. Install the propeller in accordance with the user manual . 1. The propeller deformed seriously. 2. Low battery. 3. Incorrect installation of propeller. 4.
The drone could not hover and tilts to one side. The drone indicator light is off. Could not see the picture. Hard to control by cellphone. 4 5 6 30 7 1. Practice and read the cellphone controlling instruction carefully. 3. Buy a new camera box from local seller to replace. 1. Not experienced enough. 2. Cut off the wire and re-connect. 2. There is interfering signal nearby. 3. Damaged camera. 1. Check the wire and connect well. 2. Buy a new battery from local seller to replace the battery.
For technical support visit visti us at www.flykolibri.com FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide residential protection against harmful interference in a residential installation.
