Instructions / Assembly

2461 - Instructions Arctic Cat Wildcat Short Shield Revision 01 WWW.KOLPIN.COM

INSTALLATION INSTRUCTIONS

ARCTIC CAT WILDCAT SHORT WINDSHIELD

PART # 2461

Please read and understand these instructions completely before installation to avoid injury to yourself, damage to the vehicle or accessory.

Be certain to follow all specifications. For proper installation, two people are required

Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or

upon completion of installation. Torque specifications must be followed when tightening bolts.

Parts List (parts available with kit only and not available separately)

Note that a few components of the vehicle are not depicted on the drawings in order to make the installation

instructions as clear as possible.

1. Installation

a) To apply the edge guard (Item B) to the windshield (Item

A), find a clean flat area where you can lay down the

windshield. Partially remove the protective film on both

sides and apply the edge guard using manual pressure to

ensure good adhesion to the windshield.

b) Attach clamps (Item C) using supplied hardware (Item D) to the roll cage of your vehicle as per drawings. Do not tighten the clamps

to the roll cage at this stage; you will need to make adjustments later on.

ITEM

PART NAME

DESCRIPTION

QTY

Windshield

CNC windshield cut-out made of ¼" thick GE MR10 polycarbonate or equivalent

INSTRUCTION

BAG

Edge guard strip for lower shield

Includes : 18" edge guard strip [end user to cut to exact length]

Clamp set (1 ¾" dia.)

Includes : 2 x male clamp parts and 2 x female clamp parts

Nuts & bolts

Includes : 4 socket cap screws M6 x 20, 4 locknuts M6 and 4 knobs M6 x 16

Dash contour 17"

edge guard strip

Socket

cap

screws

M6 x 20

Male clamp

parts

Female clamp

parts

Locknuts

PAGE 1
INSTALLATION INSTRUCTIONS ARCTIC CAT WILDCAT SHORT WINDSHIELD PART # 2461 Please read and understand these instructions completely before installation to avoid injury to yourself, damage to the vehicle or accessory. Be certain to follow all specifications. For proper installation, two people are required Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or upon completion of installation.
PAGE 2
c) Install the windshield to all clamps using supplied knobs (Item D) without applying final torque. Adjust the position of the windshield and tighten all screws with specified torque indicated below. M6 x 16 knobs IMPORTANT : Torque specification Max. 5 foot-pounds Applicable to all Clamp screws M6 x 20 Windshield (If torque tools are not available, stop tightening as soon as both male and female clamp parts touch as per picture below.) 2.