Instructions / Assembly

Rev. 00
Kolpin Outdoors, Inc. I 205 N. Depot Street I Fox Lake, WI
(877) 9KOLPIN or [phone] I www.kolpin.com I [e-mail]
6” Light Bar (P/N - 97991)
Parts List:
Tools Required
Drill, ¾” Drill Bit,7/16” Drill Bit, Exacto Knife, File,
17mm Wrench/Socket, 6mm Hex Key
Installation Instructions
1. Determine the mounting location of the light on the vehicle. The
light can either be mounted using the internal hex screws on each
end (Image A) or the extrusion (base) mounts (Image B).
2. If using the extrusion mounts make sure the mounting hole is large
enough for the 10mm bolt (use 7/16” drill bit to enlarge mounting
hole if necessary).
3. Slide the extrusion mounts onto the light as shown below, run bolt
through mounting hole on vehicle and tighten. Mounting order
should be: Bolt head, washer, half-moon extrusion, base mount
extrusion, mounting fixture, washer, and nut.
4. Determine a mounting location of the switch on the dash. Confirm
that there is room behind the dash for the switch. Drill a hole in the
dash with the ¾” drill bit, using a file to enlarge the hole until the
switch fits tight.
5. Route wires from desired location of light under the dash to the
location of the switch and then to the battery terminals.
6. Connect the harness to the light.
7. Connect the flat connectors to the switch in the dash.
8. Connect the ring connectors to the battery or accessory power.
9. Secure wires away from any moving parts or high heat areas.
10. Check for operation of the light.
Item
Spare P/N
Description
Quantity
1
N/A
Harness
1
2
77991
Switch
1
3
N/A
LED Light
1
4
N/A
Base Mount / Hardware
2
5
N/A
Hex Screw
2
3
Image A
Image B