Contents 1.DESCRIPTION PERPETRATION A.Transmitter Connection B.Locating & Tracking Buried Wires .. C.Measuring Depth D.Tracking Behind Walls E.Locating Circuit Breaker F. Pinpointing Drill Sites G.Determining Which Receptacles are on Specific Circuits H.Locating Alarm, Sound & Computer Wires I. External Earphone J.Locating Hidden Receptacles K.White LED Flash Light 3.SPECIFICATIONS 4.MAINTENANCE [Ry Ip 1. DESCRIPTION 1.
2. OPERATION A. Transmitter Connection To locate non-energized cable, Push transmitter switch to “Cable Scan” . There are two options for connection. You can connect one lead of the transmitter to the cable and the other lead to grounded harts or you can ‘connect ane conductor with grounded earth of a non-shielded drop wire. You can also connect two conductors to non-shielded drop wire. B.
E. Locating Cultural Breakers {Light Commercial & Residential Applications) Ta locate the circuit breaker for a specific outlet, the hookup procedure Is the same Proceed to the breaker box and remove the panel so the wires leading Into the breakers are exposed and tum the receiver on the high tone. NOTE: Dus to varying Installation techniques, the signal might ba strong on mare than one wire on the same phase and J] AC interference or computer data buzz may be present.
G. Determining Which Receptacles are on Specific Circuits Set up transmitter as outlined In Figure 01 and radius adjacent outlets with antenna. You will have a tone at the receptacle/outlet the culture. If a clear signal Is not received, that outlet Is not part of the culture you ars detesting. H. Locating Alarm, Sound & Computer Wires To locate other wires, it is best to disconnect the wire in question and directly attach only ons transmitter lead to the subject wire, letting the other lead hang.
4. MAINTENANCE The only field service required for maintaining proper operation is the periodic replacement of the batteries in the transmitter and receiver. A. Battery Replacement A WARNING Before opening the case, remove the test leads from the culture and shut off the unit. Allure to observe these warnings can result in severe injury or death. B. Cleaning abrasives or solvents. C. Service persons or things.