Installation Sheet

Circular 3 / Circular 6
Circular 3 / Circular 6
Circular 3 / Circular 6
Circular 3 / Circular 6
For Circular 3 model,
cover the unused
holes with the
provided fillers.
After wiring is completed,
remove the hanging strings
and secure the cover plate
by fitting the two screws in
from the sides.
Limited Product Warranty
Koncept warrants to the original purchaser of this product against manufacturer defects in design, assembly, material, or workmanship, and will, at
Koncept’s opon, replace or repair any defecve product free of charge. This coverage is valid for five years from the date of purchase as long as the
original purchaser owns the product. In the case of a hardwired product, this warranty is valid for one year for the LED driver specifically. Koncept will
replace or repair the product, which Koncept, at its sole discreon, agrees is defecve, free of charge provided that the following condions for a
return are fulfilled.
This warranty does not apply to any product damaged by accident, physical or electrical misuse or abuse, improper installaon, alteraon, any use
contrary to its intended funcon, war, fire, flood, or any other acts of nature, or unauthorized repair. This warranty does not apply to the LED driver
in the case of a hardwired product. A one year warranty applies to all hardwire drivers, while the five year warranty applies to the actual product.
Koncept assumes no liability for any events such as fines arising out of the use of this product or any consequenal damages caused by any failure of
the product to funcon properly. In no event shall Koncept be liable for more than the replacement of the product. This warranty does not cover
shipping or labor costs associated with the replacement of a defecve product. Under no circumstances should this warranty or the product covered
by it be construed as an insurance policy against loss of any kind. Koncept staff neither assumes nor authorizes any person or organizaon to make
any warranes or assume any liability in connecon with the sale or use of this product.
This warranty covers only products used in the territory covered by your local distributor. This is the complete product warranty and no other warranty
exists. Some jurisdicons may not allow limitaons on how long an implied warranty lasts, or the exclusion or limitaon of incidental or consequenal
damages, so the above exclusions or limitaons may not apply to you. This warranty gives you specific legal rights, and you may also have other rights
which vary in different states and countries.
To file a replacement/repair claim under the warranty:
1) Contact Koncept for a return authorizaon number during the warranty period. A claim will not be accepted without a return authorizaon
number.
2) Provide a copy of the original purchase receipt with purchase date and product name clearly shown.
3) Return the defecve product to Koncept, freight prepaid, accompanied by (1) and (2) to the following address: Limited Product Warranty, Koncept
Inc. 429 E. Hunngton Drive, Monrovia, CA 91016
Warnings
Overheang may result in reduced LED lifespan:
• Keep out of direct sunlight.
• Remove plasc bag from lamp before use.
• Recommended ambient temperature: under 77 °F.
Koncept Inc.
429 E. Huntington Drive
Monrovia, CA 91016, USA
Phone: [phone]
Fax: [phone]
Customer Support:
[e-mail]
Warning: To reduce the risk of fire, electric shock or injury:
• Do not use in wet locaons
• Do not handle plug or appliance with wet hands
• Do not stare directly at LEDs
Web Address:
www.koncept.com
Specificaons
Register your Koncept LED lamp online and receive:
• One Year Warranty Extension
• Priority Product Servicing
Visit www.koncept.com/productsupport and enter your
serial number (S/N: XXXXXXXX) located on your product.
Model SUB
Color Temperature 3000 K
Light Color So Warm
Brightness Adjustability
Compable w/ELV or LED dimmers
Input voltage 120V only
*The provided drrywall
anchors should only be used
with drywalls 1/2" thick or
less.*
Using the holes in the canopy
as a guide, mark drill hole
locations (for the mounting
screws/anchors) on the
ceiling. Using a 3/8" drill bit,
drill a hole in the ceiling where
each drywall anchor will be
located. Fold the flaps, then
insert anchor into the hole
until it is flush with the ceiling..
Insert the provided mounting
screws through the canopy
holes & into each anchor.
Always feed each pair of wires through
the holes opposite each other.
v.01302020
There are 2 rows of wire terminals for the
positive (red) wires and negative (black)
wires respectively. Connect the positive
wires to the positive terminals and
negative wires to the negative terminals.
DO NOT insert more than 1 wire into a
wire terminal.
Fit the cable
through the cable holder
and tighten using the
provided hex key. Lower each
pendant to desired height.