User Manual

Usage of the

transmitter

Features Main Menu

Connecting

the receiver

Notes on

installing

Description

Index

Back Key

Enter Key

JogDial

+/- Key

Reset

Function Menu

TH ACCEL (Throttle Acceleration) 2

Setting Item

Range of setting value

When set large value at set up, increase Consumption electric currents, It will

cause of damage to servo.

advice

To use ET or BT with other function. Modified at "SET UP" function (page 60).

An Ideal setup isn't know till actual run. because it will change in various factors (Servo, Car,

road surface, etc.)

Start swing action, When throttle trigger was position between POS.LOW and POS.HIGH.

Set the swing width at WIDTH. This function can adjust during running, when assign it to ET (from

ET1 to ET5) the "WIDTH" (set the "WIDTH" to 100)

"CYCLE" can adjust during running the cycle of swing action When assign this function to ET (From

ET1 to ET5)

Can assign to the BT1 or BT2, on/off of functions.

When activate on/off at BT button, then even if the setting are not effective (ex. "WIDTH" is 0),

The Throttle Acceleration Indicator be flashing.

WIDTH(Width) Set the swing width

POS.LOW(Low Position) Set the lower part of throttle trigger for swing action

POS.HIGH(High Position) Set the upper part of throttle trigger for swing action

CYCLE(Cycle) Set the cycele of swing action

Setting Item Maximum Minimum Initial value

ACCEL.WIDTH 100 0 0

ACCEL POS.LOW 100 0 5

(Can not set higher value than POS.HIGH)

ACCEL POS,HIGH 100 0 50

(Can not set lower value than POS.LOW)

ACCEL CYCLE 100 1 97

DRAF