User Manual

36
3・4CH 3・4ch Menu
->KEY:OFF
TRIM0
BRAKE100
THHOLD0
HIPOINT 100
REVERSENORM
MODENORMAL
->KEY:OFF
->KEY:OFF>>>
->KEY:OFF
->KEY:OFF
3CHMODE：AMP
ETMODESET
3CHMODE:AMP
NORMAL:
BURN ：ON
DIG ：ON
＜＜＜
F HOLD：ON
ON
R HOLD：ON
▶ AMP Mixing MODE











  
 




  



 
 
  




    


    


    

    

    


  



 









 

      



       
        


      

P
P
P
P
           
     
   

P
On glow engine cars, an overly high setting value will
increase load on the servo and lead to it being damaged.
Check carefully while adjusting.
On glow engine cars, an overly high setting value will
increase load on the servo and lead to it being damaged.
Check carefully while adjusting.
On electric cars, a setting value that is too small
may cause problems with the ESC settings. Make
adjustments starting from the default setting (100).
On electric cars, a setting value that is too small
may cause problems with the ESC settings. Make
adjustments starting from the default setting (100).
Brake will not operate if the value is set to 0.
Brake will not operate if the value is set to 0.
