Instructions for use KN-KT3S

Functions
Battery LED Indicator
Battery Installation
Warning: Never disassemble batteries or put the batteries in fire, chemical
agents, otherwise they may cause personal injuries or property damages.
Battery Disposal: Observe corresponding regulations about wasted battery
treatment regulations.
1. After running out of power, dispose of wasted batteries in designated areas
far away from water supply, household areas and planted areas.
2. Submit the wasted batteries to specific recycling stations.
Works with 4 x 1.5V AA
Batteries (not provided),
KT3S+NEO can be operated
a few hours. Installation:
Remove the battery
compartment cover as
shown below.
Install the batteries
observing the polarity
marked on battery
compartment.
Then reicompart-
ment cover as the
picture shown
below.
- During normal operation, the LED should be solid green ON-
- When battery voltage is dropped below 3.8V, the LED will become red color,
to indicate battery is low, you should replace new battery as soon as possible
* Always turn on the transmitter first by sliding the switch on the left side from
bottom to top. The green lights above the switch should light up. If not, you
need to check for low or incorrectly installed batteries.
1. Steering : Adjust the steering trim to
keep the front wheels in straight line when
steering wheel remains in NEUTRAL
position.
2. Throttle : Adjust the throttle trim to
ensure the wheels stop rotating when
throttle trigger remains in NEUTRAL
position (only for nitro).
For EP vehicles, this button must be
set to NEUTRAL (calibrate the NEUTRAL
with ESC).
Pre-Run Check
LED
indicator
Indicator
LED
Battery
Compartment Tray
Steering Trim Dial
Steering Wheel
Throttle Trigger
Throttle Trim Dial
BIND / EPA Key
Antenna
Power Indicator
ATV
Switch
Power
ON / OFF
Throttle
Reverse Switch
Steering
Reverse Switch
KT3S+NEO Transmitter
Steering Wheel : Control direction (Left / Right) of the RC model
Throttle Trigger : Control speed and direction
(Forward/Brake/Backward) of the driving
model.
Battery Compartment Tray : Cover and hold the batteries powering the
transmitter.
Antenna : Transmit signal to the model
Power ON / OFF : Power ON / OFF the transmitter
SYNC & Battery Indicator : Top Green LED light indicates
synchronization status
and/or adequate battery power supply.
Switch: Every impulse controls CH3
ATV : Adjustable Steering Rate by ATV dial
ST. Trim Dial : Adjust the neutral position of steering servo
when model wheels are straight ahead.
TH. Trim Dial : Make sure the model stays still when
releasing the throttle trigger.
BIND: Pairing
EPA : End Point Adjustment
WARNING: accidental or intentional EPA function manipulation may
cause servos malfunction (reduced or inexistant travel). Please
reset maximum default values before contacting your dealer
(see ).
5
For obvious reasons of security, the KONECT KT3S+NEO radio system is equipped with an automatic power shut
down of the receiver when the user turns the transmitter On while turning the steering wheel or touching the
throttle trigger.
Consequently on ignition, the vehicle won’t (for example) unintentionally accelerate. The transmitter Led flashes
red, and the user cannot use it anymore. Then it must be turned Off and On without touching anything else.
6
ENG
TRANSMITTER