User's Manual
Table Of Contents
- Important Safety Instructions
- Compliance Statements
- Warnings, Cautions and Notes
- The Guide
- Table of Contents
- Chapter 1 Preparation
- Chapter 2 Control Panel
- Chapter 3 How to Use the Printer
- Chapter 4 Problems and Solutions
- Chapter 5 Printer Maintenance and Technical Service
- Appendix A Specifications
- Appendix B Paper Specification
- Appendix C Command Summary
GSX-190II User's Manual
- 18 -
3. Raise the paper guide upright, and then turn on the printer.
4. Slide the left edge guide until it reaches the triangular guide mark. Next, adjust the right edge guide
to match the width of your paper. (As shown in figure 3-4)
5. Slide a sheet of paper down firmly between the edge guides until it meets resistance. The printer
loads the sheet automatically. (As shown below)
6. Adjust the printing home position according to the steps in chapter 2.2.4 if necessary.
Note: Don’t feed the paper with Paper feed knob, or it will influence the paper not feeding
properly.
Figure 3-3 Raise the paper guide upright
Figure 3-4 Adjust the paper guide
Figure 3-5 Insert cut sheet