User's Manual

GSX-190II User's Manual
- 19 -
3.1.2 Loading Tractor Paper
For easy to switch between printing on cut sheets and tractor paper, or easy to tear off tractor paper
sheet by sheet, you should use the tractor in push position. The printer comes with the tractor installed
in this position at the factory settings.
Using drive tractor:
1. Make sure the printer is turned off. Remove the paper guide and place the paper select lever in the
tractor paper position. Open the printer window, and then adjust the gap adjust lever according to
paper type.
2. Make sure the tractor is installed correctly (refer to chapter 1).
3. Pull the sprocket lock lever of the drive tractor upwards to release the sprocket. (As shown below)
4. Slide the left sprocket referring to the scale on the printer. The printer prints to the right of the 0 scale.
Push the left sprocket lock lever to lock the left sprocket in place. Then slide the right sprocket to
match the width of your paper, but do not lock it. Move the paper support so it is midway between the
tractors. (Shown as figure 3-8)
Figure 3-6 Adjust gap adjust lever
Figure 3-7 Release the sprocket
Figure 3-8 Adjust the position of the sprockets