User's Manual

GSX-190II User's Manual
- 25 -
3.3 Printer Setting Descriptions
This section describes all the settings available in the Menu Setup Mode.
Options Description
SYSTEM SETUP
EMULATION Specify printer's control commands.
LANGUAGE Specify the printer menu language as English or Chinese.
CHAR. MODE
Select ASCII or Chinese character mode to print when printer receives character
printing task.
CHARACTER
FONT
Specify a kind of ASCII fonts to print when printer receives character printing
task. If the print data with font instruction, printer gives priority to print data
instruction. (Only valid when CHARACTER MODE is choosing ASCII)
ENG PITCH Specify the ASCII character spacing in characters per inch (cpi).
CHI PITCH Specify the Chinese character spacing in characters per inch (cpi).
INTL CHAR SET
Specify the printer internal character set according to different using
circumstances of international characters.
CHARACTER SET Specify character set as Italic Character or Graphic Character.
IBM CHAR TBL
Select IBM character table 1, which the position from 80H to 90H of character
table are control codes.
CODE PAGE
Select the code page according to different national characters use
circumstances.
PAGE LAYOUT
LINE SPACING
Specify the line spacing in lines per inch (lpi). If the print data with vertical pitch
instruction, printer would give priority to print data instruction.
FORM LENGTH
Specify the page length of the form, for both cut sheet and continuous paper.
Printer feeds to next page according to the specified page length. If the print data
with page length instruction, printer would give priority to print data instruction.
FORM LOCK
After selecting this function on, printer would lock the page length setting. Printer
feeds to next page according to the current setting parameter and would not
affected by the page length instruction of the print data.
PAGE SKIP
After selecting this function on, printer would leave one inch (25.4mm) margin at
the perforation of the tractor paper automatically. If the print data with page
margin instruction, printer would give priority to print data instruction.
COMPRESS
PRINT
After selecting this function on, printer would print out transverse compressed
content according to the specified percentage in normal speed. When
auto-compress mode is selected, printer would detect paper width automatically
and choose the proper percentage to print.
PRINT SETUP
PRINT DIR
Select the printing direction of the print head: unidirectional, bidirectional or
selected via software.
PRT-SPEED
Specify the print speed of printer. Printing resolution is lower while print speed is
higher.
AUTO LF
If this function is on, printer would advance the paper one line automatically after
receiving every carriage return instruction.
TEAR OFF
Select the function of feeding the paper to tear off position ON or OFF in tractor
paper mode. After selecting this function on, if the printer receives FF command
for a period of time, but receives no printing data, printer would feed the page
bottom to tear off position automatically.