User's Manual

GSX-190II User's Manual
- 3 -
1.4 Choosing a Place for the Printer
When selecting a place to set up your printer, choose a convenient location that provides the following
items:
1. A flat, stable surface.
2. Adequate room around the printer to allow easy operation and maintenance. Make sure it’s close
enough to the computer for the printer cable to reach, and be sure you can easily unplug the power
cord.
3. Moderate environmental conditions. Select a cool, dry area and protect your printer from direct
sunlight, excessive heat, moisture, or dust.
4. Appropriate power source. Make sure you use a grounded outlet; do not use an adapter plug. Avoid
electrical outlets controlled by timers or wall switches; an interruption in power can wipe out the
information in your computer or printer memory.
If you place the printer on a stand, follow these guidelines:
1. Use a stand that supports at least 9 kg (19 lb).
2. Never use a stand that tilts the printer. Always keep it level.
3. Provide enough clearance below the stand and between the printer rack and the legs of the rack so
the tractor paper flows smoothly.
4. Place cables so they do not interfere with paper feeding; secure them to a leg of the stand if
possible.
1.5 Installing the Printer
Follow the steps in this section to install your printer.
1.5.1 Installing the Paper Feed Knob
1. Insert the paper feed knob into the hole on the right side of the printer.
Note: The D shape of knob should be aim at the D shape shaft inside the printer case.
2. Push firmly on the knob until it fits against the printer case.
Figure 1-6 Install the paper feed knob
Paper feed knob