Installation Guide

Rev – 14/11/16

El-080

QUICK INSTALLATION GUIDE

Clean the surface of dust and remember that if your work is on painting, wallpaper, plaster or plywood panel,

you will have to use a metal lath to ensure the adhesion.

Combine material from several boxes and blend them

in order to achieve a more natural look. Always begin

by installing corner pieces first.

Depending on the material, an electric cutter, angle

grinder, or handsaw may be used to cut stone pieces.

Clean the stone of all traces of dust and apply the

mortar based adhesive on the whole back side of

the stone evenly. Press the piece firmly to the

surface ensuring that mortar sets properly.

Make sure you prepare a thick grout mix. Always

use a grout bag and apply evenly, being careful that

the grout does not spill on the stone.

Remove excess grout with a brush handle and

detail the grout with the bristles.

Your wall is ready. You can use sealants, anti-graffiti

or water repellent to give the desired finish.

Note: Consult building codes that apply according to regions and / or country; adapt this installation procedure.

Compliance with these regulations is the full responsibility of the user and installer.

PAGE 1
QUICK INSTALLATION GUIDE Clean the surface of dust and remember that if your work is on painting, wallpaper, plaster or plywood panel, you will have to use a metal lath to ensure the adhesion. 2 1 Combine material from several boxes and blend them in order to achieve a more natural look. Always begin by installing corner pieces first. Depending on the material, an electric cutter, angle grinder, or handsaw may be used to cut stone pieces.
PAGE 2
IMPORTANT ASPECTS TO CONSIDER Koni Materials® ships freshly made manufactured stone. This fresh made stone will typically achieve 90% of its true color after approximately 30 days of manufacturing (based on good weather conditions). An expected chemical reaction allows for a proper “curing” of the color.