Installation Guide

Quick
Installation Guide
1. Clean the surface and place the
adhesive, Type S or Type N, on the back
of the stone/brick evenly.
2. Mix several boxes to achieve a more
natural application. Always begin
installing the stone/brick with corners.
Clean the surface of dust and remember that if your work is over paint,
wallpaper, drywall or plywood, always use metal mesh to ensure adhesion.
3. If cuts are needed use a masonry saw.
Press the pieces firmly against the surface
to ensure adhesion.
4. Always use a grout bag and apply grout
uniformly, careful not to drain.
6. Your wall is ready. You can use sealants,
antigrafitti, or water repellents to give the
desired finish.
5. Remove excess grout with a brush
handle and detail with the bristles from
the same brush. Never use a metal brush.
Note: Check building codes that apply in each region and/or country.
Compliance with these regulations is the sole responsibility of the user and installer.
www.KONIMATERIALS.com