Printer Operating Instructions

1.15

Getting started

*3: This option appears only if the optional NIC (network interface card) has been installed.

Level one function Level two function Level three function Summary of setting Default setting Page

B. User Settings 2.Fax Settings 01.Scan Parameters You can set the following settings for send fax message.

• Primary resolution mode Normal 4.1

• Primary contrast mode Normal

02.Print Parameter You can set the following settings for receive fax message.

• Reduction rate Auto

• Reduction margin 24 mm

4.3

• Half-page reception Off

03.# of Rings Number of rings before your machine answers. Two times 4.4

04.Redial Number of times and interval for automatic fax redialing. Two times

4.5

Three minutes

05.Dialing Pause Dialing pause length. Two times 4.5

06.Memory Tx On/Off setting for Memory transmission. On 4.2

07.Quick Memory Tx On/Off setting for Quick Memory transmission. On 4.2

08.TTI Tx On/Off setting for sending your TTI. On 4.2

09.ECM Mode On/Off setting for ECM mode. On 4.1

10.Block Junk Fax Reject the fax reception from unauthorized incoming faxes. Off 3.53

11.Security Rx Keep all received fax messages in memory and after print them. Off 3.49

12.PIN Mode Prevent unauthorized long-distance calls. Off 3.51

13.Passcode Enter passcode for limiting polling access. — 3.15

14.Audible alarm When your machine receives a fax message, it will sound the

Off 3.22

alarm tone.

15.Dial Prefix Enter the appropriate access number to access the alternative

— 3.23

telephone service provider.

3.Copy Settings 01.Scan Parameters You can set the following settings for copying.

• Primary document type Text 4.6

• Primary contrast mode Normal

02. Print parameter You can set the margin for copying. 24 mm 4.6

03.Auto Reset Time Set the time (minutes) of resetting the copy parameters. 3 minutes 4.7

04.Copy Auto Set the default setting to “Auto” for one of the following:

Paper size 4.7

• Paper size • Reduce/Enlarge ratio • Document size

05.Copy Protect On/Off setting for Copy protection. Off 2.17

06.Sort Copy On/Off setting for Sorting copy. On 4.7

07.Nega/Posi On/Off setting to reverse copy of black and white areas. Off 2.17, 4.7

4.Printer Settings 01.TCP/IP*

Enter the IP Address, Subnet mask and Gate way address. — —