User's Manual
43
Chapter 3
3.4.1 Registration of the
AeroDR Detector
By registering the AeroDR Detector on the CS-7, it is
possible to move it between different exposure rooms.
1
Make sure that all the devices in the destina-
tion exposure room are usable.
2
Insert the AeroDR Detector into AeroDR Bat-
tery Charger in the destination exposure room.
• Registration process will start.
Exposure
side
3
Once the registration is completed, a
buzzer will sound on the AeroDR Battery
Charger, and the LED (green) will change
from slow fl ashing to lit.
LED (green)
4
Confirm that the AeroDR Detector icon is
displayed on the CS-7.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
•
Once it is registered in a new exposure room, it will not be us-
able in the previous exposure room. When returning to a previ-
ous exposure room, perform the registration operation again.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT
•••••••••••••••••••••••••••••••••••••
•
Charging will also start when the AeroDR Detector
is inserted into the AeroDR Battery Charger, and the
AeroDR Battery Charger LED (blue) will light.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
3.4
●
Registration and selection of the AeroDR Detector
3.4.2 Selection of the AeroDR
Detector
An AeroDR Detector is selected as follows depending
on the number registered on each CS-7.
Number of reg-
istered AeroDR
Detectors
Selection method
1
•
AeroDR Detector is selected
automatically when that AeroDR
Detector is ready to be selected.
•
The AeroDR Detector is not se-
lected if it is not set in a bucky that
matches the order information.
Multiple
•
The AeroDR Detector that was
selected immediately beforehand
will be selected automatically if it is
ready to be selected.
•
If there is no AeroDR Detector in
the bucky that matches the order
information, no AeroDR Detector
will be selected.
HINT
•••••••••••••••••••••••••••••••••••••
•
The LED (green) of the selected AeroDR Detector is lit.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
3.4.3 Manual selection of the
AeroDR Detector
Selecting the AeroDR Detector manually is performed
with the following procedure.
1
Press the selection switch of the AeroDR
Detector that will be used.
Selection switch
2
After selection is completed, the LED
(green) of the AeroDR Detector is lit.
Reference
•••••••••••••••••••••••••••••••••••••
•
The AeroDR Detector can also be selected manually
from the CS-7. For details, refer to the “CS-7 Opera-
tion Manual”.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
①
②
⑤
④
③
HINT
Reference
IMPORTANT