User's Manual

46
31 Startup and shutdown
312 Startup of this device
Thestartupmethodsofthisdeviceareasfollows.

AeroDR Interface Unit, AeroDR Generator
Interface Unit and Access Point
• The startup methodsof theAeroDR Interface
Unit,AeroDRGeneratorInterfaceUnit andAc-
cessPointareasfollows.
1
Turn the power switch of the AeroDR In-
terface Unit on, and conrm that the LED
(green) lights
PowerswitchLED(green)
2
When the power switch of the AeroDR
Interface Unit is turned on, power is also
supplied to the AeroDR Generator Inter-
face Unit, and the LED (green) will ash
LED(green)
HINT
•••••••••••••••••••••••••••••••••••••
• InAeroSyncmode,theAeroDRGeneratorInterface
Unitisnotused.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
Normally,thisdeviceisusedwiththepoweron.
Whennotusedformorethan1day,operatethestart-
up/shutdownasfollows.
Reference
•••••••••••••••••••••••••••••••••••••
• Refertothe"OperationManual"oftheimageprocessing
controllerregardingon/offfortheimageprocessingcontroller.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
311
Startup sequence of this
device
Thestartupsequenceofthisdeviceisasfollows.

When using AeroDR Interface Unit
1 AeroDRInterfaceUnit
AeroDRGenerator
InterfaceUnit
AccessPoint
2
Imageprocessingcontroller
3 AeroDRDetector
4
AeroDRBatteryCharger/
AeroDRBatteryCharger2
ConrmthattheAeroDRDetectorisreadyfor
useontheimageprocessingcontroller.

When using AeroDR Interface Unit2
1 AeroDRInterfaceUnit2
AccessPoint
2
Imageprocessingcontroller
3 AeroDRDetector
4
AeroDRBatteryCharger/
AeroDRBatteryCharger2
ConrmthattheAeroDRDetectorisreadyfor
useontheimageprocessingcontroller.