Manualshelf

User's Manual

ManualsBrandsKonica Minolta ManualsAll in One PrinterBizhub 215
21222324252627282930
bizhub 215 3-15
3.4 Network Settings
3
3.4.4 Enabling/disabling WEB
1 Press +, to select [WEB SETTING], then press OK.
2 Press +, to select [DISABLE] or [ENABLE], then press OK.
% Whichever of [DISABLE] or [ENABLE] is selected, [ACCEPTED] appears and the screen returns to
the Network Settings screen.
3.4.5 Enabling/disabling LPD
1 Press +, to select [LPD SETTING], then press OK.
2 Press +, to select [DISABLE] or [ENABLE], then press OK.
% Whichever of [DISABLE] or [ENABLE] is selected, [ACCEPTED] appears and the screen returns to
the Network Settings screen.
3.4.6 Enabling/disabling SLP
1 Press +, to select [SLP SETTING], then press OK.
2 Press +, to select [DISABLE] or [ENABLE], then press OK.
% Whichever of [DISABLE] or [ENABLE] is selected, [ACCEPTED] appears and the screen returns to
the Network Settings screen.
3.4.7 Enabling/disabling SNMP
1 Press +, to select [SNMP SETTING], then press OK.
2 Press +, to select [DISABLE] or [ENABLE], then press OK.
% Whichever of [DISABLE] or [ENABLE] is selected, [ACCEPTED] appears and the screen returns to
the Network Settings screen.
3.4.8 Enabling Auto Get Time
Tips
- If AUTO GET TIME is enabled:
The transmission date and time are automatically affixed to data sent by the San to E-Mail or Scan to
Server (FTP/SMB) function and the same date and time are recorded as transmission logs.
- If AUTO GET TIME is disabled:
The transmission date and time is not added to data sent by the Scan to E-Mail or Scan to Server
(FTP/SMB) function. Only the transmission number is added. No date or time is recorded as transmis-
sion logs.
1 Press +, to select [AUTO GET TIME], then press OK.
2 Press +, to select [SNTP SETTING], then press OK.
3 Press +, to select [OFF] or [ON], then press OK.
If [OFF] is selected, the screen returns to the Auto Time Settings screen.
If [ON] is selected, [ACCEPTED] appears and the screen returns to the Auto Time Settings screen.
% If [ON] is selected, you need to proceed with NTP server configuration. For the procedure to enable
automatic detection of the NTP server using IPv6, refer to page 3-16. If IPv4 is in use or if you wish
to specify the NTP server directly, refer to page 3-16.
% After configuring the NTP server, to specify the interval for obtaining time data, refer to page 3-17.