User's Manual

9
Specifying management settings
9-42 200/250/350
Specifying management settings Chapter 9
Specifying POP3 reception timeout settings (mode 358)
You can specify the time until a timeout of the SMTP server connection oc-
curs when receiving e-mail messages.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
(*)
After changing the settings, the machine must be turned off, then on again.
2
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off.
The machine may not operate correctly if it is turned on immediately after
being turned off.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 1 0 0 0 0 0 (HEX: 20)
Bit Description Setting Description Page
Refer-
ence
7, 6, 5, 4 Specifies the time until a
timeout of the SMTP server
connection occurs when
sending e-mail messages.(*)
0001 30 seconds ---------
0010 60 seconds
0011 90 seconds
0100 120 seconds
0101 150 seconds
0110 180 seconds
0111 210 seconds
1000 240 seconds
1001 270 seconds
1010 300 seconds
Other *Do not specify other set-
tings than the above.
3, 2, 1, 0 -----------------------------
0000 *Do not change these bits
when specifying settings for
this function.
---------