User's Manual

Specifying management settings
9
200/250/350 9-51
Specifying management settings Chapter 9
Specifying whether to enable access locks, and whether to enable the
password rules (mode 469)
Specify whether to lock access if the password is entered incorrectly, and
specify whether to apply the password rules.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
2
Note
For the Access Lock function, refer to User’s Guide [Copy Operations].
If applying a password rule, the conditions that are required in the pass-
word are described below.
8 alphanumeric characters (only 8 alphanumeric character for the admin-
istrator password, and 8 alphanumeric characters or more for the user
authentication user password)
Only passwords with the same characters are not allowed.
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page
Refer-
ence
7 Specify whether to
lock access when a
password (account
track and administra-
tor passwords) is en-
tered incorrectly three
times.
0 Does not lock access ----------
1 Locks access
6, 5 ---------------------
00 * Do not change these bits
when specifying settings
for this function.
----------
4 For security, specify
whether to apply a
password rule.
0 Do not apply a password
rule
----------
1 Apply a password rule
3, 2, 1, 0 --------------------- 0000 * Do not change these bits
when specifying settings
for this function.
----------