User's Manual

9
Specifying management settings
9-54 200/250/350
Specifying management settings Chapter 9
Specifying settings to limit the use of communication modes-2 (mode
476)
Specify whether to permit or prohibit the use of individual communication
modes. Prohibited communication modes do not appear in their selection
screens.
2
Note
Programmed one-touch dial buttons can be used for transmission even
if a prohibited communication mode has been specified.
If all communication modes are prohibited (modes 475 to 477), some
screens, such as those for specifying transmission settings, may not nor-
mally be displayed.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions of the corresponding functions.
1 Specifies whether or
not the use of SNMP
is prohibited.
0 Permitted ----------
1Prohibited
0 -----------------------
0 *Do not change this bit
when specifying settings
for this function.
----------
Bit Description Setting Description Page Refer-
ence
Bit 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page Refer-
ence
7 Specifies whether or
not the use of the
Scan to SMB opera-
tion is prohibited.
0 Permitted ----------
1Prohibited
6 Specifies whether or
not the use of SMB
printing is prohibit-
ed.
0 Permitted ----------
1Prohibited
5 Specifies whether or
not the use of G3
faxing is prohibited.
0 Permitted ----------
1Prohibited