Instruction Manual

Parameter Option Description
Stapler sub tray
●
Multi hole punch—This option is available only if the multi hole
punch module is connected.
●
Punch—The values vary according to the type of punch unit
connected. The number of holes is 2, 3, or 4.
Stapler Main
tray
●
Staples
○
None
○
Rear
○
Front
○
Dual
●
Multi hole punch—This option is available only if the multi hole
punch module is connected.
●
Offset
Stapler Fold
tray
●
Fold type
○
Multi half fold
○
Multi tri-fold-in
Center staples—Staples the center of the booklet (Multi half fold
only)
Finishing tab in the job parameters window 193