User Guide

Using the PLAY Menu (Cont’d)

6. The “SELECT SET” screen appears.

Use the  or  button to select “LAST

SET FILE READ” or “INIT. VAL. <0>”

and then press the SET/DISP. button.

• If you do not want to specify any DPOF

settings, select “CANCEL” and press the

SET/DISP. button.

• By selecting “LAST SET FILE READ”, you can re-use the file containing the previous

print settings. If the previous settings are not stored in a file, this option is grayed out

and cannot be selected. In this event, select “INIT. VAL. <0>”.

• By selecting “INIT. VAL. <0>” and pressing the  or  button, you can reset all the

frames to their default values beforehand.

7. An 8-frame image is displayed.

Use the , ,  or  buttons to move

the red frame around the screen. Using

the red frame to select an image allows

you to change or set (or cancel) the

DPOF settings for the image.

- Images for which prints have been specified are surrounded by a yellow frame and

the number of prints specified is shown in the top-left corner of the image. By using

the red frame to select an image and pressing the zoom buttons (T and W), you can

increase or decrease the number of prints.

- If you use the red frame to select an image with no prints specified and then press

the SET/DISP button, the number prints for that image is set to 1. You can then use

the zoom buttons (T and W) to increase or decrease the number of prints.

• If you press the  button at the first frame or the  button at the last frame, the

screen changes to show the previous 8 frames or next 8 frames.

8. To exit the selection screen, use the , ,  or  button to select “END”

and then press the SET/DISP. button. (Proceed to p.100-10.)