User Guide

1 Introduction
15
Note
5. Using the 10-key pad, enter the IP
address of the IF-102 (Internet Fax
kit).
• The screen at the right shows an
example of an entered IP address.
For the appropriate setting, consult
the network administrator.
6. Press the
[ENTER]
key.
The “
NETWORK(FAX/SCAN)
”
menu appears again.
To set the “SUBNET MASK” function
1. From the “
NETWORK(FAX/SCAN)
”
menu of the INITIAL SET mode,
press the
[2]
key from the 10-key pad
to select “
SUBNET MASK
”.
2. Using the 10-key pad, enter the subnet
mask value.
• The screen at the right shows an
example of an entered subnet mask.
For the appropriate setting, consult
the network administrator.
3. Press the
[ENTER]
key.
The “
NETWORK(FAX/SCAN)
”
menu appears again.
•“AUTO” is available if a DHCP server is on the network. If “AUTO”
is selected, it will not be necessary to specify the subnet mask or
gateway settings.
• If a fixed IP address has been set, you must select “IP Address in
NVRAM” in the enclosed Network Management Utility Light. Make
this setting in the “TCP/IP Configuration” menu on the “Network”
tab. For more details, refer to the Network Management Utility
Light for IF-102 User’s Manual.
IF-102.book Page 15 Friday, June 21, 2002 1:22 PM