User Guide

3 Network Scanning
51
3.2.1 Using the Automatic Document Feeder
1. Press the
[SCAN]
key.
The machine enters Scan mode, and
the scan screen appears.
2. Load the document to be scanned into
the Automatic Document Feeder.
• Adjust the Document Guide Plates
to fit the size of the document.
• Load the document with the side to
be scanned facing up.
3. Press the
[SPEED DIAL]
key, and then
use the 10-key pad to enter the 3-digit
speed dial number.
• Specify a speed dial number
between “101” and “110”.
• The FTP server can only be speci-
fied with a speed dial number.
In addition, the speed dial numbers
are programmed with the FTP server
addresses using Network Manage-
ment Utility Light. For details, refer
to the Network Management Utility
Light for IF-102 User’s Manual.
• If you wish to change the entered FTP server address, press the
[NO]
key, and then enter the correct address.
• If nothing is programmed in the specified speed dial number, an error
message appears. Enter the correct speed dial number.
IF-102.book Page 51 Friday, June 21, 2002 1:22 PM