User Guide
3 Network Scanning
52
4. Press the
[ENTER]
key.
• If settings such as the resolution are
not to be specified, press the
[START]
key, instead of pressing the
[ENTER]
key.
5. Using the and keys, select the
desired resolution (200
×
200 dpi, 300
×
300 dpi or 600
×
600 dpi), and then
press the
[ENTER]
key.
• To specify detailed Scan mode set-
tings, press the key.
For details on changing the settings,
refer to “ To change the Scan mode
settings” (p. 48).
6. Using the and keys, select
“
ADF
”, and then press the
[START]
key.
• To change the scanning size, press
the key.
For details on changing the setting,
refer to “ To change the scanning
size” (p. 49).
7. Press the
[START]
key to begin scan-
ning, then connect to the FTP server
and upload the scan data.
Tip
• In order to send to a specified recipient (only one) a notification of the
FTP server address where the data was uploaded, set “E-mail
Notification” when programming the speed dial number using Network
Management Utility Light. For details, refer to the Network
Management Utility Light for IF-102 User’s Manual.
IF-102.book Page 52 Friday, June 21, 2002 1:22 PM