Users Manual Part 1
1
2
3
4
5
6
7
8
9
10
11
12
Operation of DR Detector
67
3
PushtheexposureswitchoftheX-rayde-
vice to perform the exposure�
• After exposure, images are saved to DR Detec-
tor, and the information LED indicates the num-
ber of saved images.
4
Exit Aero Storage mode�
• Insert DR Detector into the AeroDR Battery
Charger or AeroDR Battery Charger2, or con-
nect it to a wired cable.
• Aero Storage mode exits, and DR Detector is
connected to the image processing controller.
5
Import the images using the image pro-
cessing controller�
Aero Indicator
Exposure with Aero Indicator is performed with the fol-
lowing procedure.
IMPORTANT
• Do not give diagnoses using the images displayed in Aero
Indicator.
• Images displayed in Aero Indicator are for positioning
check, and the display diers from the image displayed in
the image processing controller.
• When performing exposure using Aero Indicator, align the
orientation of the triangular mark of the DR Detector with
the orientation of the grid bar as shown in the following g-
ure.
DR DetectorGrid
Grid bar
Triangular mark
• If the orientation of the grid bar tilts 90° from the orientation
of the triangular mark of the DR Detector at exposure, the
image display unevenness may occur on Aero Indicator.
• The image unevenness on Aero Indicator due to the orien-
tation of the grid bar will be removed upon image process-
ing when the image is imported to the image processing
controller.
1
Start the Aero Storage mode of the DR De-
tector�
2
Start Aero Indicator of the DR Detector to
beaccessedfromamobiledevice,and
log in to Aero Indicator�
3
ChecktheconnectedDRDetector,andtap
[OK]�
4
Ensure that the status of Aero Indicator is
readyforexposure,andperformanexpo-
sure operation�
5
Check the preview image displayed in
Aero Indicator� The image is displayed
duringthereceptionprocess,andthepre-
view image is displayed�
6
Exit the Aero Storage mode of the DR
Detector as well as Aero Indicator on the
mobile terminal�
7
Import the image using the image pro-
cessing controller�
HINT
• If reconnect to the DR Detector that imported images to the
image processing controller without exiting Aero Indicator,
the following screen is displayed. Tap [Refresh] to refresh
the imported image as well as exposure failure and division
display displayed on the mobile terminal.