Users Manual Part 2
85
1
2
3
4
5
6
7
8
9
10
11
12
3�6
PositiontoaxDRDetectoridenticationlabelandAeroDRGripsheet
3�6�1 PositiontoaxDRDetector
identicationlabel
When using more than 1 DR Detector and affixing
identication labels (stickers) to the outside of the DR
Detectors, it is recommended to ax the labels to the
2 places ((1), (2)) shown as follows.
IMPORTANT
• Ax the labels only in the recommended places. Failure to
do so may cause the labels to come o or image uneven-
ness to occur.
PositiontoaxDRDetectoridenticationlabel
(1) (2)
(1) (2)
HINT
• Use of commercially available vinyl (Tepra, etc.) labels are
recommended for the identication labels (stickers). When
possible, use labels that do not easily peel o.
• It is recommended to write the name and identification
number registered in the image processing controller on
the label.
3�6�2 AeroDR Grip sheet
When using the AeroDR Grip sheet, hold the DR De-
tector as shown in the following gure.
IMPORTANT
• The AeroDR Grip sheet may peel o or deteriorate depend-
ing on usage. When AeroDR Grip sheet peel o or deterio-
rate, replace them.
• For replacement AeroDR Grip sheet, contact Konica Mi-
nolta technical representatives.
• For how to affix the AeroDR Grip sheet, refer to "6.1.5
AeroDR Grip sheet axing and replacement".
• The AeroDR 1012HQ and AeroDR 3 Detector do not use
the AeroDR Grip sheet.
AeroDR Grip sheet
AeroDR
Grip sheet