Service Manual

DRUM UNIT
3-30
III DIS./ASSEMBLY
4. Remove the 2 screws [1], and remove the drum
bearing [2].
5. Remove the 2 semicircular seal blocks [3] (one
on each end of the drum).
6. To remove the drum, lift it up and out from the
front side.
Note:
• Take care to avoid scratching the drum's light
sensitive areas and the cleaning blade. Do not
touch these areas with bare hands.
• When removing or installing, never allow the
drum to bump against the plate-metal part of the
cleaning blade.
• If you are going to place the drum in storage, be
sure to place a cover on the drum (to cut off light
to it) and store it in a dark place.
• When removing the drum unit, do not place your
hand on the separation claw unit.
[1]
[2]
[3]