Service Manual

DRUM UNIT

3-35

III DIS./ASSEMBLY

A. Procedure

1. Remove the transfer and separation corona unit

from the main body.

2. Use a tweezers to remove the hook [1] from the

transfer and separation corona unit. Then

remove the plunging prevention plate [2].

3. Remove the spark arrestor plates/F [1], /R [2].

4. Move the cleaning block to home position, and

remove the top covers [1] from the cleaning

block.

5. Remove the spring [2] from each wire, and

remove the wires [3].

Note:

• When removing the wire, be careful that the wire

holding rubber that is in touch with the V-shaped

rack [4] does not get lost.

6. Reinstall the above parts following the removal

steps in reverse.

Note:

• When installing the wire, be sure that the cleaning

block is in home position at the right side. Stretch

the wire so that it fits into the V holders [4].

[1]

[2]

[1]

[2]

[1]

[2]

[3]

[4]