Service Manual

TONER SUPPLY/CLEANING/RECYCLE UNIT
3-39
III DIS./ASSEMBLY
7. TONER SUPPLY/CLEAN-
ING/RECYCLE UNIT
7.1 Removing and Reinstalling
the Toner Bottle
A. Procedure
1. Open the front door [1], and then open the toner
supply cover [2].
2. Pull the toner bottle [3] slightly out, and turn it
clockwise so that the upper part of the cartridge
aligns with the cutout.
3. Withdraw the toner bottle [3].
4. Reinstall the above parts following the removal
steps in reverse.
7.2 Removing and Reinstalling
the Toner Supply Unit
A. Procedure
1. Remove the drum unit and developing unit.
2. Remove the toner bottle.
3. Remove the rear cover.
4. Remove the system control board unit.
• For removal procedure, see “2.1 Removing and
reinstalling the motor units (main, fixing, feed,
developing)”.
5. Remove the drum rotating plate.
6. Remove the 4 connectors [1].
7. Remove the 4 screws [2], and remove the toner
supply unit [3] by pulling it toward you.
8. Reinstall the above parts following the removal
steps in reverse.
[1]
[2] [3]
[1]
[2]
[3]