Service Manual

PAPER FEED UNIT
3-46
III DIS./ASSEMBLY
5. Remove the 2 stop rings [1] and the bearing [2].
6. Remove the feed shaft [5] from the rocking shaft
[4] while raising the shaft on the left side of the
paper feed roller unit [3], and remove the paper
feed roller unit [3].
7. Remove the collar [1] and pull out the feed shaft
[2].
8. Remove the feed rubber [4] from the feed roller
[3].
9. Remove the stop ring [5] and pull out the paper
feed shaft [6].
10. Remove the paper feed rubber [8] from the
paper feed roller [7].
11. Reinstall the above parts following the removal
steps in reverse.
Note:
• Be sure to install the feed rubber [4] so that the
paint mark [9] is turned in the direction as shown
in the illustration.
• Install the paper feed roller unit so that the hook
of the paper feed roller unit comes above the
paper feed roller unit release arm.
[1]
[1]
[2]
[4]
[5]
[3]
[11]
[10]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]