Service Manual

FIXING UNIT
3-54
III DIS./ASSEMBLY
4. Detach the faston terminal [1] at the front of
each lamp.
5. Remove the 2 screws [2], and remove the lamp
support piece/F [3].
6. Keeping all cord faston terminal wiring straight,
pull each fixing heater lamp/1 [4], /2 [5] toward
you to remove.
7. Reinstall the above parts following the removal
steps in reverse.
Note:
• When installing, be sure that manufacturer's mark
is mounted on the front side.
• Do not allow the heater lamps to make contact
with the inside of the roller.
• Install so that the main lamp is at the top, and the
sub lamp is at the bottom.
Heater cords are color-coded as follows.
• When installing the faston terminal on the drive
gear side, be sure that the installation position is
correct.
Lamp
Color Positions
JAPAN U.S.A.
EUROPE
OTHERS
Front Rear Front Rear Front Rear
Main White White Red Red Blue Blue
Sub White Black Red Black Blue Black
[1]
[2]
[3]
[4]
[5]