Service Manual

FIXING UNIT
3-60
III DIS./ASSEMBLY
B. Procedure
1. Remove the fixing unit from the main body.
2. Remove the fixing claw unit.
3. Remove the fixing web.
4. Remove the two fixing heater lamps.
5. Remove the 2 screws [2] and 2 collars [3] for the
connector [1] that was connected to the faston
terminal. Remove the connector [1].
6. Remove the 2 screws [4], and remove the lamp
support piece/R [5].
7. Open the fixing guide [1] to release the pres-
sure.
8. Remove the C-ring [3] at the rear of the heat
roller [2], and then remove the gear [4] and heat
insulating sleeve/A [5], /B [6].
9. Remove another C-ring [1], then remove the
heat insulating sleeve A [2] (the sleeve toward
the front).
10. Remove the 2 fixing bearings/U [4] (one at the
front, one at the rear) from the fixing unit.
11. Remove the fixing heat roller [3].
Note:
• When the installation, be sure that heat insulating
sleeves A and B are oriented and positioned cor-
rectly.
When replacing the heating insulating sleve/A [5],
apply solvest 240 [7] to the inside and outside
surfaces of the heat insulation sleeve/A [5] and
then install it.
[1]
[2]
[3]
[4]
[5]
[1]
[2]
[3]
[4]
[4]
[5]
[5]
[6]
[6]
[7]
[2]
[3]
[1]
[4]