Service Manual

I ADJUSTMENT
25 MODE
1-16
3
DIPSW20 0 Separation of defective part
of Network
Normal Not allowed to
use
000
1 Separation of defective part
of IEEE1284
Normal Not allowed to
use
000
2 Separation of defective part
of USB
Normal Not allowed to
use
000
3— ——000
4 Separation of defective part
of FNS
Normal Not allowed to
use (Offset not
allowed to use)
*
000
5 Separation of defective part
of the saddle
Normal Not allowed to
use
000
6— ——000
7— ——000
DIPSW21 0 Platen size recognition
selector switch 1 for Latin
America (Inch only)
8.5 x 11 A4 0 0 0
1 Platen size recognition
selector switch 2 for Latin
America (Inch only)
8.5 x 11R A4R 0 0 0
2 Platen size recognition
selector switch 3 for Latin
America (Inch only)
8.5 x 14 F4 0 0 0
3 Notice of nonstandard small
platen size (Inch only)
Notice of
noticed size
Notice as non-
standard size
000
4 Job suspension/end at pull-
ing out key counter
*
24
*
24 0 0 0
5 Notice of small size of platen
mode (8.5x11/A4 or smaller)
Notice size
detected by
APS
Notice size as
A4 (Japan, Met-
ric) or 8.5x11
(Inch)
010
6 Switching of the count-up
function
*
25
*
25 0 0 0
7 When using an EKC, the
password screen appears at
the end of each job
No Yes 0 0 0
*
The saddle is also detached.
DIPSW No. Bit Functions 0 1 Default values
Japan Inch Metric