Service Manual

I ADJUSTMENT
25 MODE
1-23
1
*
1 FS-112 stapling upper limit
*
2 Toner level detection (toner supply display)
After the TLD (Toner level sensor) detects the
no toner condition for more than a specified
period of time, this sets a timing for displaying
the message “Please supply toner”.
*
3 Condition for stopping copying after toner sup-
ply display
After displaying a message set in DIPSW4-0/-
1, the count up to which the copy is prohibited
is set.
*
5 SW for decreased toner consumption
Decreasing the developing bias, charging grid
potential by 50V (20 step) in this setting allows
the consumption of toner to be reduced.
Increasing the potential by 50V (20 step)
allows the image density to increase a little.
*
6 Timing for the polygon motor to stop/start a
low speed rotation
When the setting of the polygon motor is
made for stopping or a low speed rotation, the
motor is shifted into a low speed rotation or
stopping after the elapse of time specified by
this DIPSW. The elapsed time starts either at
one of the following:
• When the warm-up is completed.
• When the final operation of the operation keys
(except the start key)/RADF/tray while in idling.
• When the output of a copy or print job is com-
pleted.
Mode 1-4 1-3
50 sheets 0 0
45 sheets 0 1
40 sheets 1 0
35 sheets 1 1
Mode 4-1 4-0
0 effective copies 0 0
100 effective copies 0 1
200 effective copies 1 0
500 effective copies 1 1
Mode 4-3 4-2
100 effective copies 0 0
400 effective copies 0 1
700 effective copies 1 0
1000 effective copies 1 1
Mode 5-6 5-5
No adjustment 0 0
Toner consumption
increased (image den-
sity increased)
01
Toner consumption
decreased (image den-
sity decreased )
10
No adjustment 1 1
Mode 6-5 6-4
15 seconds 0 0
30 seconds 0 1
60 seconds 1 0
120 seconds 1 1