Service Manual

I ADJUSTMENT
25 MODE
1-26
3
*
20 Operation when two position stapling is not
available
*
21 Fixing temperature at low power mode
Set the fixing temperature while in the low
power mode.
In the case of the 7145
In the case of the 7235/7228/7222
*
22 Dot diameter adjustment control
In this setting, the SW is used to change the
timing for the dot diameter adjustment.
*
23 F4 size setting
*24 Job interruption/termination operation when
the key counter is being drawn out
This is to set the operation of the copier when
outputting a print job.
The details of the operation can be changed
by the combination of this setting and the
DIPSW1:0 setting.
*
25 Switching of the count-up function
Mode 14-7 14-6
Auto cancel 0 0
Auto cancel 0 1
Inhibit 1 0
Forced 2-position sta-
pling mode operation
11
Mode 16-1 16-0
155°C 0 0
120°C 0 1
85°C 1 0
85°C 1 1
Mode 16-1 16-0
70°C 0 0
120°C 0 1
120°C 1 0
70°C 1 1
Mode 16-7 16-6
The power is off for
more than 8 hours with
humidity over 60%
00
The power is off for
more than 8 hours
(7145)
01
At all times (Every time
SW2 is turned on)
10
Non
(7235/7228/7222)
11
Mode 17-2 17-1 17-0
8.5 x 13 0 0 0
8.25 x 13 0 0 1
8.125 x 13 0 1 0
8 x 13 0 1 1
8.5 x 13.5 1 0 0
Mode 21-4
DIPSW1-0:0 Terminate by stopping
paper feed
DIPSW1-0:1 Clear jamming imme-
diately
0
DIPSW1-0:0 Interrupt by stopping
paper feed
DIPSW1-0:1 Clear jamming imme-
diately
1
Mode 21-6
Normal operation
Counting up for both the total
counter and the key counter
0
• While in copying, both the total
counter and the key counter count
up
• In the printer/FAX mode, only the
total counter counts up
1