Service Manual

I ADJUSTMENT
25 MODE
1-28
3
*
33 TSL control of user paper (tray)
This SW is used to set the TSL control which
is applicable when the specified paper is
selected in the “Paper type setting” in the key
operator mode.
When this SW is used to select the “Switched
according to the environment”, the switching
is made between “Normal control” and “All off”
according to the environment.
• “Switched according to the environment” per-
forms the TSL control according to the humidity
detected by the main body HUM1 (Humidity sen-
sor).
*
34 Selection of the transfer/separation output of
user paper (bypass feed)
When selecting the bypass tray on the copy
basic screen, this SW is used to set the trans-
fer/separation output which is applicable when
selecting the user specified paper for “Special
paper setting” or the specified paper for
“Paper type setting” in the key operator mode.
*
35 TSL control of user paper (bypass feed)
When selecting the bypass tray on the copy
basic screen, this SW is used to set the TSL
control which is applicable when selecting the
user paper for “Special paper setting” or the
specified paper for “Paper type setting” in the
key operator mode.
When this SW is used to select the “Switched
according to the environment”, the switching
is made between “Normal control” and “All off”
according to the environment.
• “Switched according to the environment” per-
forms the TSL controle according to the humidity
detected by the main body HUM1 (Humidity sen-
sor).
*
36 Automatic power on by the RADF operation
during the power save mode
In this setting, when the following operation is
made during the power save mode, the power
is automatically turned on.
• When the original is set in RADF (when the
PS301 (No original sensor) is turned off).
• When the platen/RADF is opened (when PS15
(APS timing sensor) is turned off).
• When the platen/RADF is closed (when PS15
(APS timing sensor) is turned on).
Mode 29-4 29-3
Normal control 0 0
All off 0 1
Switched according to
the environment
10
Mode 30-2 30-1 30-0
Plain paper (Japan) 0 0 0
Plain paper (Inch) 0 0 1
Plain paper (Metric) 0 1 0
Thick paper 0 1 1
Thin paper 1 0 0
Recycled paper 1 0 1
Mode 30-4 30-3
Normal control 0 0
All off 0 1
Switched according to
the environment
10
Mode 31-0
Disabled 0
Enabled 1