Service Manual

I ADJUSTMENT
36 MODE
1-60
3
8.9.1 Setting method
A. Procedure
1. Enter the 36 mode.
2. “36 mode menu screen”
Press the [3. Running mode] key.
3. “Running test mode menu screen”
Press the key according to the desired mode.
(Mode 1 to Mode 5)
4. “Basic screen”
Press the START button.
5. After checking the copy operation, press the
Stop button to stop copy operation.
6. Press the # button while pressing the
∗ button to
return to the “Running mode menu screen”.
7. To perform another running test mode, repeat
steps 3 to 6.
8. Press the [RETURN] key to return to “36 mode
menu screen”.
8.10 Test Pattern Output
Output various test patterns and use the results to
detach defective parts.
Select the [4. Test pattern] in the “36 mode menu
screen”, then the test pattern output screen will
appear.
Note:
• For modes not listed specifically on the Service
Manual, output should not be made.
A. Procedure
1. Enter the 36 mode.
2. “36 mode menu screen”
Press the [4. Test pattern] key.
3. “Test pattern output screen”
Enter a pattern number to be output from
numeric key.
4. Press the [COPY] key.
5. “Copy screen”
Select A3 or 11 x 17 and press the start button
to output a test pattern.
6. When you want to output another test pattern,
press the # button while pressing the
∗ button
and repeat the procedures 3 to 5 above.
7. Press the [RETURN] key to return to the “36
mode menu screen”.