Service Manual

I ADJUSTMENT
OTHER ADJUSTMENTS
1-99
B. Test Mode
(1) Test Mode Setting Procedure
a. Procedure
1. Turn OFF SW2 (Sub power switch) of the
copier.
2. Flip keys of the DIP switch into the ON or OFF
position as necessary. (See Table below.)
3. Turn ON SW2 (Sub power switch) of the copier.
4. This sets the Finisher into the corresponding
Test Mode operation.
b. Resetting Procedure
• Flip all keys of the DIP switch to their respective
initial positions (OFF positions) and turn OFF,
then ON, SW2 (Sub power switch) of the copier.
(2) Test Mode Operations
Test Mode
Operation
DIP Switch (S3) LED
12341234
Online {{{z
1st Tray exit ON z{{{
Elevator Tray
exit
ON {z{{
Finisher Tray
exit
ON ON zz{{
Shifting
operation
ON ON z{z{
Aligning Plate
operation
ON ON {zz{
Stapling Unit
CD movement
ON ON ON zzz{
Exit Roller/
Rolls spacing
ON {{{z
Storage Roller/
Rolls spacing
ON ON z{{z
Elevator Tray
operation
ON ON {z{z
Hole Punch
operation
ON ON ON zz{z
Hole position
selection
ON ON {{z z
Sensor test
ON ON ON
Indicates sen-
sor state
z: Blinking {: OFF