Service Manual

SAFETY AND IMPORTANT WARNING ITEMS

S-3

[2] CHECKPOINTS WHEN PERFORMING ON-SITE SERVICE

Konica Minolta brand copiers are extensively tested before shipping, to ensure that all applicable safety stan-

dards are met, in order to protect the customer and customer engineer (hereafter called the CE) from the risk of

injury. However, in daily use, any electrical equipment may be subject to parts wear and eventual failure. In order

to maintain safety and reliability, the CE must perform regular safety checks.

1.Power Supply

WARNING: Wall Outlet

• Check that mains voltage is as specified. Plug the power cord into the dedi-

cated wall outlet with a capacity greater than the maximum power consump-

tion.

If excessive current flows in the wall outlet, fire may result.

• If two or more power cords can be plugged into the wall outlet, the total load

must not exceed the rating of the wall outlet.

If excessive current flows in the wall outlet, fire may result.

WARNING: Power Plug and Cord

• Make sure the power cord is plugged in the wall outlet securely.

Contact problems may lead to increased resistance, overheating, and the

risk of fire.

• Check whether the power cord is damaged. Check whether the sheath is

damaged.

If the power plug, cord, or sheath is damaged, replace with a new power

cord (with plugs on both ends) specified by KMBT. Using the damaged

power cord may result in fire or electric shock.

• When using the power cord (inlet type) that came with this copier, be sure to

observe the following precautions:

a. Make sure the copier-side power plug is securely inserted in the socket

on the rear panel of the copier.

Secure the cord with a fixture properly.

b. If the power cord or sheath is damaged, replace with a new power cord

(with plugs on both ends) specified by KMBT.

If the power cord (inlet type) is not connected to the copier securely, a

contact problem may lead to increased resistance, overheating, and risk

of fire.

• Check whether the power cord is not stepped on or pinched by a table and

so on.

Overheating may occur there, leading to a risk of fire.