Service Manual

I ADJUSTMENT
OTHER ADJUSTMENTS
1-103
10.9 Lengthwise Position Adjustment
of Punch Hole of FS-113
A. Procedure
1. Set the copier into the Hole Punch mode and
make a 1-sided copy from a 1-sided original.
2. Fold the copy in half and check to see if the
holes are aligned
(deviation should be within 2mm).
3. If the holes are misaligned, loosen the screw
that secure the Punch Unit and slide the Punch
Unit as necessary.
4. Make a copy again and check for correct hole
positions.